I. The costume must have:
Specific to Episode II:
Tunic - Episode II: Black "officer-style" tunic. Non-glossy fabric. Collar stands up ~1/2". Slight diagonal line closure from the outer edge of the left shoulder to the waist; below the waist it is vertical. The bottom of the tunic should fall 4-5" below the waist.
Pants - Episode II: Black, officer-style pants made from the same fabric as the tunic. The pants tuck into the boots. (loose fitting straight legged pants that are bloused at the top of the boots will also be acceptable.)
Cloak - Episode II: Dark brown, non-glossy fabric. The cloak is fully lined with a satin-weave material. It falls from the shoulders to just above the ankles. The upper portion of the cloak has vertical quilt lines. These run from the front to the back of the cloak at armpit level vertically, and from the neck to the shoulder horizontally. The back of the cloak collar sits at the same height or slightly higher than the tunic collar.
Specific to Episode III:
Tunic - Episode III: Dark brown "officer-style" tunic. Non-glossy fabric. Collar stands up ~1/2". Slight diagonal line closure from the outer edge of the left shoulder to the waist; below the waist it is vertical. The bottom of the tunic should fall 4-5" below the waist.
Pants - Episode III: Dark brown, officer-style pants made from the same fabric as the tunic. (Loose fitting straight legged pants that are bloused at the top of the boots will also be acceptable.) The pants tuck into the boots.
Cloak - Episode III: Medium brown, non-glossy fabric. The cloak is fully lined with a smooth, non shiny, velvet or velvet like material material. It falls from the shoulders to just above the ankles. The upper portion of the cloak has vertical quilt lines. These run from the front to the back of the cloak at armpit level vertically, and from the neck to the shoulder horizontally. The back of the cloak collar sits at the same height or slightly higher than the tunic collar.
For both Episode II and III:
Belt: The base belt is brown leather, ~2" wide and has two "buckles", one on each side. Each buckle is made of brown leather, and is slightly wider than the belt itself. Belt buckles have 5 horizontal, overlapping leather �strips� at equal intervals.
Cloak clasps: Two silver-colored "Victorian" brooches, 2-3" in diameter. These can be made from metal pins, or metallic spray painted wood, resin, or plastic.
Cloak chain: Silver metallic chain with oval-shaped links. It hangs flat and horizontally across the upper chest, and is fastened by the clasps just below the collarbone.

Boots: Black lace-less boots with rounded toe which are either be leather or appear to be leather. They should come up to just below knee level.
Beard/moustache: You can either use your own facial hair, or high quality costuming facial hair. The moustache covers the area between the nose and lips, then tapers off past the edge of the lips and joins into the beard. Beard is trimmed closely to the chin and side of the face. It tapers slightly as it goes up the sides of the face until it meets the sideburns. Facial hair should be colored or dyed white.
Hair: The hair is not parted. It is combed straight back from a slight widow's peak at the front. At the sides, the hair curves around until it is parallel with the sideburns. In the back, the hair is off of the neck. Hair should be colored or dyed white.
Lightsaber: MR Dooku 1:1 replica, equivalent looking resin-cast, or Hasbro Count Dooku/Darth Tyranus Electonic Lightsaber. No Rubies saber.
II. The costume may have:
Lightsaber clip: If included, it must be a Covertec clip placed on the belt directly over the left hip.
Refrence Image 501st: (EPII)



This topic is locked












